3 Tips for Optimal PilePad Installation

Step 1: Height

Remove any oysters, mussels or barnacles growing within range of your boat. This is best done with a flat shovel and some force.

Check your boat’s exterior, and especially the rub rail, for exposed screws, sharp edges or other abrasive imperfections. These can tear PilePad’s neoprene shell, voiding the warranty.

The presence of just one of the factors above can significantly impact the effectiveness of your PilePads. For questions or guidance for your installation, contact us via Instagram direct message.

Step 2: Height

Remove any oysters, mussels or barnacles growing within range of your boat. This is best done with a flat shovel and some force.

Check your boat’s exterior, and especially the rub rail, for exposed screws, sharp edges or other abrasive imperfections. These can tear PilePad’s neoprene shell, voiding the warranty.

Key Takeaways:

• PilePad products provide protection from scratches, dents and dings caused by exposed structural dangers at your dock.
• Poor installation or infrequent rechecks can limit PilePad’s effectiveness.
• Our strap and buckle securing process does not require power tools or permanent installation. If you need a more fixed solution, contact Orders@PilePad.com.
• During install, focus on three factors: Height, direction and tension.
• If you have questions or are unsure about your PilePad installation, contact us.
• Visit our Installer Network page to find a certified installer in your area.